"No laboratory chiller to control water inlet temperature. I can still get numbers but this will result in constantly changing boundary conditions. Possible to get around this?"
no problem so long as you can hold a temp long enough to reach equilibrium (say +/- 0.2^C, but NOT trending)
"Flow rate measurement. I have a relatively inexpensive flowmeter that is +/- 6%. This turns out to be the major stumbling block I think."
may have a soln, looking for a link
"Still have to decide upon a way to assign watts. I'll most likely go with the Duron 1200MHz at 1.75V so that I can pull the typical max load number from the AMD spec and just go with that. Comments?"
you do need to run that matrix described earlier, too much not known
you've got the coolant nailed
be cool
|