[jtroutma]

Acutally after reading your post again.... I think you and I have almost the same idea in mind.

I was thinking about puting the heater core inside the back of the coil and then simply running a hose to the outside of the case to get water to the heater core. THe line comming from the WB will be split just before the coil and one will go to the coil and the other to the heater core.

The heater core should stick out a bit in the back. THen putting a shroud after that and another fan to pull all the warm air between the radiators out, almost creating a sort of wind tunnel.

I am suspecting the fan will stick out about 5" out the back of the case.

Was that what you had in mind also BigBen2k?