[Dr_Pentium]

I'm using distilled water, i dont think there should be any corrosion since both the rad and block are copper, i did buy a junction box a circular one, the initial plan i had was to use the junction box to make the res with a clear front, but the problem is that the tubing i have is braided and its quite thick, the plus it doesnt crinkel (spell) but when you bend it, it needs quite a bit of room to bend. if i tried going the junction box way the only room i found was on top of my psu and the tubes wouldnt bend to where the res was. I know everyone is using tygon but its just too damn expensive, vinyl tubing is just to crap, so i had to go with 1/2' i.d braided tubing