View Single Post
Unread 06-24-2002, 04:21 PM   #1
ZaVkE
Cooling Neophyte
 
ZaVkE's Avatar
 
Join Date: Jun 2002
Location: Belgium
Posts: 83
WB-design for direct pelt cooling *revised*

new design:



This is the new design.
The small cilinders in the waterarea don't restrict much but still put high pressure on the pelt.

So this time i have a large (practically unrestricted) waterflow that make contact with the entire hotside of the pelt (except for a small edge) so the pelt should be cooled fine.
There is al lot of pressure on the pelt wich can be adjusted by the 8 holes. The pressure is evenly spread over the entire pelt so he should function good.

Could you please give some comments or suggestions about this design.

thnx
__________________
signatures are for wussies
ZaVkE is offline   Reply With Quote