Pro/Forums - View Single Post

#Rotor · 06-25-2002, 09:13 PM

Ya... it's as easy as pie.... get a nice little reservoir with a fairly beefy pump, a couple of T or Y connectors, absolutely have to use 1/2" id tubes for the infrastructure. I would recommend medium flow high velocity blocks though...

connect all the pc's up with the blocks in parallel.

you will have to run a Heater core, properly ventilated.

in this picture you can see the core and the open reservoir with the 210GPH Beckit. note the temperature of the liquid, even with 4 overclocked DURONS and a chipset in the loop.

here is some pictures of two of the nodes, the other pc is my Dualy.

06-25-2002, 09:13 PM	#2
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	Ya... it's as easy as pie.... get a nice little reservoir with a fairly beefy pump, a couple of T or Y connectors, absolutely have to use 1/2" id tubes for the infrastructure. I would recommend medium flow high velocity blocks though... connect all the pc's up with the blocks in parallel. you will have to run a Heater core, properly ventilated. in this picture you can see the core and the open reservoir with the 210GPH Beckit. note the temperature of the liquid, even with 4 overclocked DURONS and a chipset in the loop. here is some pictures of two of the nodes, the other pc is my Dualy.