Quote:
Originally posted by MeltMan
But... You want the water to spend the MOST time in the rads to remove the most heat... Dividing flow amongst 2 radiators would half the flow to each, but after going through the rads the flow comes back to gether.
Its like Ohm's law. Two resistors (rads) in parallel equal 1/2 the resistance (flow cut)
|
Yes, but the point here is that the flow MIGHT fall under the minimum flow for a single rad, therefore reducing the efficiency.
If the flow is high enough, it'll make little to no difference, except that the overall flow is higher, which the CPU WB likes.