Hi I have the same case and I installed the aqua coil above the power supply. To do it, purchase a peice of sheet metal from home Depot, I think it was a 5x7 Piece. and attched it to the other end of the radiator so the inlet/exit tubes will face inward the case. In the back of the case I cut a 120mm hole in the back. So right now the radiator is setup as Fan Grill/Case/120mmFan/Sheet Metal/radiator/120mm fan.
I purchased the Maze2-1 with the 3/8" from danger den
danner mag-drive 250 from aquacoil.
You can buy all the fitting for it at Home depot.
My temp dropped 10C and even with the 2 120mm fans it is still quiet. I also kept two fans up front. If you want I'll send you some pics in a couple of days. I have to buy some batteries for this digital camera
|