Pro/Forums - View Single Post

chazz469 · 06-26-2002, 01:41 PM

This is the setup that I was envisioning.......

The hosing would be all 1/2 in. braided vinyl, until I could afford enough tygon (braided vinyl =$.45/ft., tygon=$2.35/ft). The rads would most likely be heater cores (maybe BIXs, but HC are cheaper and better), except for PC4 which would have the DD Cooler Cube that's already in it. The rad/fan units would NOT lay on the PCs just for airflow purposes. PC4 also already has the MAZE3, why use earlier MAZE blocks (honest question Brad)?
Feedback???

06-26-2002, 01:41 PM	#4
chazz469 Cooling Savant Join Date: Jun 2002 Location: San Diego, CA Posts: 150	This is the setup that I was envisioning....... The hosing would be all 1/2 in. braided vinyl, until I could afford enough tygon (braided vinyl =$.45/ft., tygon=$2.35/ft). The rads would most likely be heater cores (maybe BIXs, but HC are cheaper and better), except for PC4 which would have the DD Cooler Cube that's already in it. The rad/fan units would NOT lay on the PCs just for airflow purposes. PC4 also already has the MAZE3, why use earlier MAZE blocks (honest question Brad)? Feedback??? __________________ "I believe that the moment is near when by a procedure of active paranoiac thought, it will be possible to systematize confusion to the total discrediting of the world of reality" -Salvador Dali AMD XP1600+ @1790MHz and rethinking my cooling.... MAZE3 --> DD Cooler Cube --> Eheim 1048 512MB PC2700 DDR MSI KT3 Ultra-ARU 2x 20GB Maxtor in RAID 0 1x 30GB Maxtor --> WinXP GF3 Ti200 @ 240/499