View Single Post
Unread 06-28-2002, 04:37 AM   #16
artemis0007
Cooling Savant
 
artemis0007's Avatar
 
Join Date: Sep 2001
Location: Davis, CA USA
Posts: 113
Default

Personally when I contemplated using an external design, I would just drill holes for the bulkhead quick connects (1 for in and 1 for out). For the box containing the w/c stuff, just drill two holes a little bit larger than the tubing OD. I would use some rubber around the hole to make sure that no jagged or sharp edges could puncture the hose. Then I would use some black drainage pipes (the crinkled kind) to put around the 2 tubes in between the two boxes to protect and insulate them.

That's what I was gonna do. I hope that helps.
artemis0007 is offline   Reply With Quote