Quote:
Originally posted by unregistered
Les
wrt the die area:
open up the flow area to, and from (in the top plate)
then 'pinch' the flow from the sides (you're not trying to cool the corners)
and look for a low volume/high pressure pump
then you can put a good 'squeeze' on it
be cool
|
Bill.
Yes/No to both profile and pump.
It depends on which direction I take.
Have 3,enthusiasm dependant, plans:
1) Look-see at DAI by fitting a central inlet (keeping 2 oulets and same internal dimensions)
2) Obtain some Diode temps to compare with my "In Socket" Peltier temperatures - initial reason for getting a Diode reader.
3) Look-see at the inclusion of an intermediate shim and a crack at that TIM analysis nightmare - have you any intentions of a revisit?