this gd pos forum software won't hold a post while the window is being reused
bigass time waster
Les
1) my suggestions were to reverse the cross-sectional flow area 'ratio' over the die area when flowing corner to corner (narrow-wide-narrow to wide-narrow-wide, relatively of course)
this, across an optimized surface, will test the turbulent parallel flow scheme
jet impingment normal to the bp will certainally produce turbulence, the problem is that at our 'level' of testing we cannot easily demonstrate which is better
and cannot 'calculate' anything at all relating to such
I have all the wb test pieces to quantify flow rate/nozzle velocity/wb 'thermal resistance'; just doing other things right now
2) not my bag, good luck
3) doing goop testing 20hrs a day (Cooling Flow is better for testing), and just added another
http://www.evertech.com/category.cfm?Category=60
typical confusion (about testing)
here
this review was fairly well done
(looks like I need to do an article on goop testing, jk)
be cool