Pro/Forums - View Single Post - New To watercooling!! what a disaster! Help!!

Acroam · 07-03-2002, 03:37 PM

ok, its a submersible pump, not inline, and i ran it through to make sure there was no air bubbles at all. I am using Vcool as a temperature readout, without all the idle loops and extras, just plain temperature readouts. I ran a few games and it was about 136-138 after playing them for about 30 min.

MeltMan= For the answers about the heater core, the heater core is used. The water flows through it at the same rate as it does without the heater core hooked up. I think its probably the pump and the block. I can blow through both the block and the heatercore as well.

07-03-2002, 03:37 PM	#32
Acroam Cooling Neophyte Join Date: Jul 2002 Location: Somewhere Posts: 85	ok, its a submersible pump, not inline, and i ran it through to make sure there was no air bubbles at all. I am using Vcool as a temperature readout, without all the idle loops and extras, just plain temperature readouts. I ran a few games and it was about 136-138 after playing them for about 30 min. MeltMan= For the answers about the heater core, the heater core is used. The water flows through it at the same rate as it does without the heater core hooked up. I think its probably the pump and the block. I can blow through both the block and the heatercore as well. Last edited by Acroam; 07-03-2002 at 03:40 PM.