Pro/Forums - View Single Post

artemis0007 · 07-04-2002, 02:31 PM

Hi all!
After test fitting my bits, I finally have a res design for you all to comment on.

NOTE: The inlet and outlet positions cannot be changed because of where my reservoir will be located.

My main concern was whether or not this res would make a mini waterfall. I'm not sure if having a small waterfall effect would create more air bubbles or release more. In any case, I was thinking of cutting the plug's height in half for better flow. Other than that I would like suggestions. Thanks!

This res will fit into the 2 3.5" bays at the front of my YY cube case and the plug will stick out from the top of the case.

07-04-2002, 02:31 PM	#1
artemis0007 Cooling Savant Join Date: Sep 2001 Location: Davis, CA USA Posts: 113	res question Hi all! After test fitting my bits, I finally have a res design for you all to comment on. NOTE: The inlet and outlet positions cannot be changed because of where my reservoir will be located. My main concern was whether or not this res would make a mini waterfall. I'm not sure if having a small waterfall effect would create more air bubbles or release more. In any case, I was thinking of cutting the plug's height in half for better flow. Other than that I would like suggestions. Thanks! This res will fit into the 2 3.5" bays at the front of my YY cube case and the plug will stick out from the top of the case.