They are 5/8 inch fittings all my setups are flow optimized. All the fitings even of the rad and res/pumps have at least 1/2 id. Unlike all the systems out there with 1/2 inch barbs that have 1/4 id.
As for the pics down at the bottom of the page below the pic you can click the link that says view full size. This will give you the full size screenshot. In most cases this will 1280x1024. Should be big enough to see easily.
Priceing will be 45$ for the blocks. So I'm hoping that is competative. We are looking at getting some custom pelts to fit on them also.
The big thing will be our custom case work which will also be competative. Can't say more on this but you will see.
|