looking at it this Am--it is confusing-sorry--Last nite it was clear to me Lol-
The main thing I was asking or thinking to get reduandancy ,I would have to move the botton T to the block. Then the 2 pumps would be "butting heads" and I just think there wouldn't be any flow through the top loop. The way it is now-If I shut off the A Via 1300 the water from the 1048 loop goes up the T and across the block, back to pump. Only thing to do is try it. That will be a test for another day. Last week when setting this up and testing, I decided to see how loud the fans were gonna be at 12v and 7v. So i set a 2x4 across top of case to hold a bowl of water to act as a reservior. Then set up my enermax 465 w/a jumper and usually a old cd player to give me load--that day just picked up my new maxtor ata133 to use and started checking noise with the 3 120mm fans and spliceing fan connectors to make 7v. I looked up and seen water was getting low in bowl, so got my gal jug and added some water to bowl and hit the 2x4 and launched the bowl of water on to the PSU and hard drive. It made severl LOUD pops before could turn power srip off. Scratch 1 hard drive-PSU lost 1 of its fan and only puts out 4.65 v on its 5v line.I got it to post when MB is at FAILSAFE settings but it won't run windows. I swore off testing for at least a week. It sounds like something from the "3 stooges" but it scared the XXXX out of me at the time.
I think I am gonna leave it set up like it is. Thanks
|