Has anyone gotten a BIX to fit in the bottom-front of their PC65 (new model) or know of a better position to place a rad for a closed loop system w/ res.
my initial thought was to have the rad standing up where the dual fans are, but would there be enough room under the case if it was laying down instead?
(images NOT to scale
)
(above) i'm not too sure if the BIX has enough clearance by itself or with a shroud (under the 3.5 drive cage above it).
vs
(above) the problem with this is that if i put it on the floor, it can start sucking up lint unless i put a filter but that'll restrict airflow. Or maybe just putting the BIX on the bottom and just 1 Panaflow M1A sucking air though the BIX (or should i stick with two?).
I'd preffer the second method so i dont need to remove my front USB ports. The front usb port pcb/connector is in the way and would need to be removed if using the first pic.