[Lothar5150]

Originally posted by awesterink
gmat: no, I did not glue the impeller to the shaft...did not know about this...worth a try! Is that described in a thread somewhere?

Other guys: if I go to 1/2" tubing, would the small channel in my Innovatek blocks not negate that effect? I know that a smaller channel in a block results in faster flow, which is a good thing for the block. But perhaps a 1/4" channel in the block is TOO small? Which blocks have a larger channel...? MAZE3?

Appreciate all you replies guys! I'm not giving up darned...with 60C load on my CPU, 46C case, I better do SOMETHING :-)

Swiftech MCW462-UH