Pro/Forums - View Single Post

Darkhorse · 06-11-2001, 02:15 AM

I've just got a YY cube case and am trying to figure out the best way to fit the Becooling Aquacoil radiator.

My initial thought was that I would hole saw a 120mm blow hole in the top (right) of the case & use the screws from the 120mm fan (as they are quite long) to screw the whole lot to the top of my case. But then I realised that the rad in/outlets point in the same direction as the fan meaning that the tubing would be bent through a sharp angle against the top of the case.

Thought two. I'll cut a square hole in the back of the case and sit it on top of the psu. Hmmm, I've got an Enermax 451w PSU with 2 fans (one on the back and one on the bottom) and the PSU sits upside down at the bottom of the case so I would be blocking the psu fan.

I've spent nearly 4 hours trying the rad in different places and it driving me nuts.

Anybody have any suggestions?

Thanks

AB

06-11-2001, 02:15 AM	#1
Darkhorse Cooling Savant Join Date: Jun 2001 Location: UK Posts: 103	Aquacoil radiator I've just got a YY cube case and am trying to figure out the best way to fit the Becooling Aquacoil radiator. My initial thought was that I would hole saw a 120mm blow hole in the top (right) of the case & use the screws from the 120mm fan (as they are quite long) to screw the whole lot to the top of my case. But then I realised that the rad in/outlets point in the same direction as the fan meaning that the tubing would be bent through a sharp angle against the top of the case. Thought two. I'll cut a square hole in the back of the case and sit it on top of the psu. Hmmm, I've got an Enermax 451w PSU with 2 fans (one on the back and one on the bottom) and the PSU sits upside down at the bottom of the case so I would be blocking the psu fan. I've spent nearly 4 hours trying the rad in different places and it driving me nuts. Anybody have any suggestions? Thanks AB