Pro/Forums - View Single Post

Jimbo · 07-19-2002, 07:45 AM

I've finally gotten together most of what I need for my first water setup. I purchased a Danger Den chipset block to go along with a Maze 3 but I'm not sure of the best way to setup these two blocks.

The pump I currently have is an 600LPH/158GPH Eheim 1048 and I went with a cheaper Black Ice Prime radiator. To get to the point. I would like to setup both the cpu and chipset blocks but I'm concerned about too much heat being delivered to the Chipset block from the cpu if I run the two in series.

If I go with a Y splitter at either side of the two blocks, is the 1048 enough to handle two splits in the tubing? Can anyone direct me to some good links which break down the amount of force needed to handle various tubing setups? Thanks in advance.

-jim (hot stank) M.

07-19-2002, 07:45 AM	#1
Jimbo Cooling Neophyte Join Date: Jul 2002 Location: NY Posts: 12	New to H2O..a few setup questions I've finally gotten together most of what I need for my first water setup. I purchased a Danger Den chipset block to go along with a Maze 3 but I'm not sure of the best way to setup these two blocks. The pump I currently have is an 600LPH/158GPH Eheim 1048 and I went with a cheaper Black Ice Prime radiator. To get to the point. I would like to setup both the cpu and chipset blocks but I'm concerned about too much heat being delivered to the Chipset block from the cpu if I run the two in series. If I go with a Y splitter at either side of the two blocks, is the 1048 enough to handle two splits in the tubing? Can anyone direct me to some good links which break down the amount of force needed to handle various tubing setups? Thanks in advance. -jim (hot stank) M. Last edited by Jimbo; 07-19-2002 at 08:46 AM.