my eheim 1048 is actualy quite small. And, if you want a smaller pump you may want to get a rio, there are lots of closed loop and mini-res mods for them. Check around. And about the noise on the monitor, is your monitor signal cable near the power cable for the pump, it if's not shielded that could be causing the distortion. You could also have a defective EMI shield, in any event, you'll deffinitely wanna have the pump checked out. These pumps have to meet prety strict FCC regulations just like everythin else elictrical/electronic and it shouln't do that. Well, good luck with your situation.
--Matt
*Update* I put my spare 1048 right next to my monitor and ran it, there was no interference.
|