Quote:
|
Volenti, are the two inlets at the parrallel port end, then two outlets at the ddr end?
|
That is correct. When I was testing the blocks flowrate I noticed that the water exiting the block was... "rough" for want of a better term, presumably I'm getting a fair bit of turbulence inside, with a flow of 1500L/H (400GPH) it had
better be turbulent
this will be my "testbed" block, since I can easily un-solder it and expriment with various geometric shapes inside.
Though I want to refine the entry and exit to be more flow friendly than the current setup, see if I can eek some more flow rate.