hmmm ducting sounds interesting g.i.
might try to do something with that.
The question i have is, if my rad and fan are mounted in the front of the case, that would mean i have to do some ducting all the way till the back of the case and then cut out a hole for the duct?
also the duct would ahve to be the same size as the fan rite ? so 120mm diameter.
Another thing when ducting, do angles matter ? if my duct takes an extreme 90 degree turn, nothing should matter rite?
i just thought of this idea, using the silver ducting you can buy at home depot.
Cut 2 120mm holes in my plexi glass on my sidepanel, use 1 hole for a 120mm fan, then in the other hole i would run the ducting from there to the fan mounted on the rad. Make sense ?
I know all my fans are exhausting air from the case, i was thinking adding a 120mm rite on to my window to get some intake air.
As far as the tiny holes go in th back of the inwins, i cut them all out with a dremel so not a prob.
I really wanna try wat lucifer said earlier about using an old 120mm fan casing as a shorud or duct, only problem is i dont have an old 120mm to spare
, guess i'll have to find something else to work with.
guess i'll have to soon start modding again.
