Okay, I don't want to lose my original question here. I ask that everyone read this post carefully.
1. The Spir@l is the best waterblock for my CPU (AthlonXP) at the moment.
2. At first (since I am relatively new to watercooling) I should stick to a basic setup - CPU only.
3. After I get better, I can add a video card and chipset waterblock, preferably on their own loop, using the best blocks available at that time.
And here's what I was thinking for my setup:
Spir@l for CPU
D-tek Heater Core ($30 is pretty much cheaper than locally.)
Danner MAG Drive pump (Locally, shooting for around 350GPH.)
Tygon from D-Tek.
Probably going to need a fan too, still deciding, that's no biggie.
(I'll probably make my own shroud when the time comes.)
|