[V12|V12]

Hey there, must be nice to have friends in cutting places! Any how, I'd suggest, if you have access to a CNC miller, do a spiral-like design or something like the maze, but instead, have 3 taps, one large inlet in the middle and to smaller ones on the outside. Or you could simply mick the maze 3 design, which is pretty nice... Just look around on the forums and check out others designs and get to brain storming!

Hey, how's about checking out the post on "ultimate block" theory, there are some GREAT design ideas there too! Like the one about half way down the page, it mimics a heater core design, except that the inlet and outlet are on opposing sides. GOod luck on whatever you design!