Pro/Forums - View Single Post - Offset of new "upgrade" Danger Den Maze 2

GuyBFF · 07-27-2001, 04:46 AM

I appreciate the measurements. I guess I didn't do to bad with my estimations from the pictures.

8cm x 5cm is 3.15" x 1.97" (about what I assumed)
2cm center to closest wall is 0.787" (which should fit within the tollerance of the new block I guessed at)

Thanks for the backup. I guess now it's really not even necessary to measure, if the inlet is near dead center, your old... almost totally over the center line, your new.

Pretty Simple.

Thanks Again Everybody, I'm definetely running the new block, hope this makes it easier for anyone else wondering

07-27-2001, 04:46 AM	#5
GuyBFF Cooling Savant Join Date: Jun 2001 Location: Winnipeg, MB, CA Posts: 242	I appreciate the measurements. I guess I didn't do to bad with my estimations from the pictures. 8cm x 5cm is 3.15" x 1.97" (about what I assumed) 2cm center to closest wall is 0.787" (which should fit within the tollerance of the new block I guessed at) Thanks for the backup. I guess now it's really not even necessary to measure, if the inlet is near dead center, your old... almost totally over the center line, your new. Pretty Simple. Thanks Again Everybody, I'm definetely running the new block, hope this makes it easier for anyone else wondering __________________ A7V8X Danger Den Maze II Danner Mag Drive 350 Heater Core Style Rad Thunderbird 1400 (Soon Barton) 512mb PC2700 CL2 Promise SX4000 Raid 5 w/256mb PC133 Cache 4x40gb Western Digital 7200hdd Plus More...