Pro/Forums - View Single Post - Water block Writeup with the big dogs!!!!

#Rotor · 08-04-2002, 11:52 PM

you are welcome.... now remember one thing with that method...... I aimed it at being as simplistic as possible. It is to give an overall idea of block flow rate, But more-so be repeatable, by anyone in the world, at absolute no cost, as far as testing equipment....

the resolution of the method is probable in to 20.0 to 60.0 LPH I was however able to get a noticeable difference, in testing the same block with 3/8 fittings, so it will be able to show a difference, if that difference is large enough to warrant a mention. And that was all the experiment was intended for.

of coarse you can make it very very accurate, just by using a much larger container.

08-04-2002, 11:52 PM	#21
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	you are welcome.... now remember one thing with that method...... I aimed it at being as simplistic as possible. It is to give an overall idea of block flow rate, But more-so be repeatable, by anyone in the world, at absolute no cost, as far as testing equipment.... the resolution of the method is probable in to 20.0 to 60.0 LPH I was however able to get a noticeable difference, in testing the same block with 3/8 fittings, so it will be able to show a difference, if that difference is large enough to warrant a mention. And that was all the experiment was intended for. of coarse you can make it very very accurate, just by using a much larger container. __________________ There is no Spoon....