my mind boggles at all the curves
I would observe that the curves in the plot "Calculated C/W vs. Flow Rate . . ", for the lower flow rates, are quite similar to those I actually measure
BUT
it is the offset for a given wb that will define the actual values - and the predictive ability of an equation
how on earth does the coolant pressure figure in this ?
FYI, I run at 5 to 8psi given how I am configuring the flow rate measurement and control
- you are suggesting that if I run at 2psi (not atypical for a WCer) I'm going to see a measurable difference ?
not too sure about this as I used to run this way and see no difference in the thermal results
be cool
|