John Doe
I'm going to be using these quick release taps from Fluval at various points so I can completly dismantle the watercooling without having to drain the whole system first. Nice part is these taps come in two halves so I can extend the system without to much hassle.
Planning on putting the vid & M/B blocks after the rad. So the setup will be pump->cpu->rad->vid->M/B. Probably fit a second rad after the last two blocks and before the pump. Depending on how the flow is from the Eheim 1250 I might put a second Eheim in parallel.
Alot of this is going to be experimentation (read fun).
I'll have a T piece to act as a filler tube instead of a resevoir, but again I'll see how it goes.
|