View Single Post
Unread 08-12-2002, 03:04 AM   #38
Brad
Thermophile
 
Brad's Avatar
 
Join Date: Oct 2001
Location: Nuu Zeeelin
Posts: 3,175
Default

Rotor - my mail checks every minute all day long, I probably had read the email before you typed that I was just too busy at work to reply all day. But I'm at home now, finally, and you've gone offline. Maybe your TigerMP is on fire right now? :P Just emailing me the two pics would be fine whenever you're online next.


Morphling, the gap between the fins would be as thin as possible, also the open part of the block would be fairly shallow, only 5mm or so. If the block was 3/4" deep then sure the performance would suck. Also I intend the base thickness to be 10mm, to spread the heat out as wide as possible.
__________________
2x P3 1100's at 1400, Abit VP6, 2x Corsair 256mb PC150 sticks, 20gb 'cuda ATA-III, 2x 40gb 'cuda ATA-IV in raid 0. 20" Trinitron. No fans

2x 2400+ at 2288mhz (16.0 x 143), Iwill MPX2, 2x Kingmax PC-3200 256mb sticks, 4x 20gb 60gxp in Raid 5 on a Promise SX6000. Asus Ti4200 320/630. Cooled by Water
Brad is offline   Reply With Quote