Well you see.. In my phase change system I only have enough room to fit the rio pump in between the evaporator coil.. in the resevior i have.. even that is a snug fit.. so I planned to either pump the water out using the rio to my larger pump.. or to just use the 3/8" opening on the bottom side of the resevior to go to my water pump.. then out to my system.. and then return back into the top of the evaporator resevior.. either way i need to have some type of other container for my aqua via pump.. there is a small leak in it so i can't run it "inline" .. it needs to be submerged.. I was hoping that this way would work.. cuz before the water gets sucked into the pump it gets brought right across the evaporator.. i mean the rio is like snugged up against the evaporator coils.. it's a perfect fit.. it's beautiful.. i figure since the water and stuff is going to be so cold the rio won't be putting out no 120gph.. more like 75-90GPH.. but once it got going the suction from my via aqua pump would bring up the GPH on the rio.. kinda equalizing things..
|