Pro/Forums - View Single Post

athlonnerd · 08-13-2002, 01:43 PM

brad, GET OUTA MY HEAD. thats exactly what i was thinking as the next design in my quest. i would have done the holes like taht, but my drilling skills were not sufficient, how did you do it? i was planning on soldering a thin copper plate on the ends ofthe block to block off the small holes. do you have any temps for us?

your temps should be like ultra awsome, becuase i got around 31-32*c in my test, but seing as i am gonna use a pelt, i had to clamp the 3/8" thick coldplate to the wb, which is very inneficient for non peltier use, so those temps would have been way lower had i included the baseplate in the original desing.

08-13-2002, 01:43 PM	#104
athlonnerd Cooling Neophyte Join Date: Jul 2002 Location: missouri city, tx Posts: 7	brad, GET OUTA MY HEAD. thats exactly what i was thinking as the next design in my quest. i would have done the holes like taht, but my drilling skills were not sufficient, how did you do it? i was planning on soldering a thin copper plate on the ends ofthe block to block off the small holes. do you have any temps for us? your temps should be like ultra awsome, becuase i got around 31-32*c in my test, but seing as i am gonna use a pelt, i had to clamp the 3/8" thick coldplate to the wb, which is very inneficient for non peltier use, so those temps would have been way lower had i included the baseplate in the original desing. __________________ xp 1600+, still to be oc'ed, 768 mb ram, msi kt266pro2, baracuuda 4 40gig, linksis nik+cable modem, jaton gf2mx400 64 meg http://www.overclockers.com/tips835, cd+cdrw fixing to do water cooling