Quote:
Originally posted by maskedgeek
dude, connect the fins all the way thru, so its in one side and out the other, that would make a sweet block! no hassle of splitting tubes and whatnots...
|
They are not connected because I belive they intended a center outlet and to side inlets or center inlet and 2 side outlets. If that is the case this would fail miserably. But if they do connect the middle fins all the way through it may not be so bad as long as the outlet/inlet where huge.
Also V12 that program is roughly $3,000 so you may want to look for an alternative. I do ALL my designing and CAM routing with ACAD2000. Works pretty good with my desktop CNC as it doesn't like the bigger mills GNC code very much.