Quote:
Originally posted by bigben2k
Ok Limeygreg, what's your baseplate thickness? How deep are the channels? what flow are you getting out of it (i.e. how restrictive is it?)?
dream caster: do you mean fins that are bent over?
|
I mean: my idea is to have long fins that go parallel to flow and short fins at 45º angle to flow between them to make the water spin: I'll probably use that for a hard disk cooler having two plates one over the other so fins will go in both sides of a long flat chamber. One hard disk will go attached to each plate.
Each side will be just like the drawing i made; in the upper side (plate) the cross fins will go one way, and in the other side, cross fins will go at 90º; just as the thread on a screw so water makes that screwing motion.
P.S. excuse me for not answering in several days ; I had thought this thread was gone.