Pro/Forums - View Single Post

#Rotor · 08-17-2002, 11:53 PM

I guess it wouldn't be that hard no, though these blocks are a tad bit on the big side.... won't fit on most boards... doesn't even remotely come close to fitting on any of mine....... I had a bit of a dilemma, as it was almost surely a once off, I didn't want to spend the materials on making a template, nun the less it was 4 plates, that had to be accurately re-produced, so templating it was kind of a requirement, I ended up using a piece of plexiglass, worked like a charm, though the softness of the plexi, will render the template rather inaccurate after about ten uses or so...

08-17-2002, 11:53 PM	#60
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	I guess it wouldn't be that hard no, though these blocks are a tad bit on the big side.... won't fit on most boards... doesn't even remotely come close to fitting on any of mine....... I had a bit of a dilemma, as it was almost surely a once off, I didn't want to spend the materials on making a template, nun the less it was 4 plates, that had to be accurately re-produced, so templating it was kind of a requirement, I ended up using a piece of plexiglass, worked like a charm, though the softness of the plexi, will render the template rather inaccurate after about ten uses or so... __________________ There is no Spoon....