Bladerunner, i had a machineist do the circle, it cost $10 total so far, well, add in $100 for a drill press, but I've been needing that for more creations. The fittings are 3/8. Maybe i should drill them to 1/2. I have no way to test flow as i still need to buy a pump, hose, and a radiator. Also mounting will be similar to BladeRunner's GF3 GPU, except the holes will be to the sides for an athlon. I hope this darn thing gets my temps below 48c. Im tired of that crap.
Future ideas, I have tons of the thickness of the top plate, i was thinking of making a 3 layer design consisting of 2 solid plates and one with the room for waterflow. What do you think? or will the solder between layers affect temps too much... I wouldnt think it would hurt it too bad since the ThermalRight SK-6's fins are soldered and it is one of the top performing copper HSF's around.. Tell me what you think. My drill press is calling...
Peace In