Pro/Forums - View Single Post - Water Maintenance Q-- n00b

Axle · 08-29-2002, 10:13 AM

It honestly didn't look all that good, just was the size that I needed. Since I'm going for quiet, I was thinking of emulating the Swifty Quiet Power barebone case ($370 no thankyou!), and put the radiator in the back with 2 Panaflos (good idea?). I'm using the Antec 1040SX(well, rip off of it).

I also don't know what to do about size. 3/8 or 1/2? I think I'd rather go with 1/2, but that takes a special order of the block, which might be more. I'm just not sure.

Hey, that would be really, REALLY wonderful if you'd do that for me, BigBen, I'd be in your debt forever.

'86 Chevette? Well that wasn't a good car at all

Thanks again, everyone!!!

08-29-2002, 10:13 AM	#6
Axle Cooling Savant Join Date: Aug 2002 Location: Wind Gap, PA Posts: 112	It honestly didn't look all that good, just was the size that I needed. Since I'm going for quiet, I was thinking of emulating the Swifty Quiet Power barebone case ($370 no thankyou!), and put the radiator in the back with 2 Panaflos (good idea?). I'm using the Antec 1040SX(well, rip off of it). I also don't know what to do about size. 3/8 or 1/2? I think I'd rather go with 1/2, but that takes a special order of the block, which might be more. I'm just not sure. Hey, that would be really, REALLY wonderful if you'd do that for me, BigBen, I'd be in your debt forever. '86 Chevette? Well that wasn't a good car at all Thanks again, everyone!!!