Hey, that's a nice drill press ya found there! Damn that's a lot cheaper than I thought they would run on E-rip! I was just wondering if anyone knew if you could replace the bearings in a typical drill press with some bearings that can handle the horizontal loading that standared milling would produce? Seems like there has to be something that could make it a lot easier... I don't know about you but $500-2000 is damn well overpriced for an overhyped Drillpress, er I mean "milling" machine, lol! That's basically all they are, drill press with differing bearing loading and usually better torque motors, anyhow cheers!
__________________
XP 1600+ AGOIA-Y (GreenLabel, UNLOCKED!@/ NF7-S 2.0/ PC 2700 DDR
10.5*172FSB(1806/ 1991 high), Vcore 1.792...@84.95Watts
--86' Chevette Heater Core
--1/2" Vinyl tubes
--Via1300-Stealth Mod(QUIET!) 
---Home made copper-tube block
---PVC small internal res
|