Quote:
Originally posted by unregistered
yup, certain paths only go so far
consider the thermal gradients involved
shorten the upstream length a bunch, downstream 1/2 as much
then boost the pressure/velocity
even so your gains will be quite slight
with a P4 you can also thin the bp, that will help more
BTW, you have a 'low flow' design; you need pressure, not volume
|
so you mean I should trim the fins more so they are mainly just over the core, say the size of the intel heatspreader, and force the water through that?
the bp is 4mm thick, little bit thinner now after I lapped it (had to lap quite a bit)
I can easily change the design, just add heat and it'll all fall apart...
and do you mean that I have a low flow
volecity design?