Here's a few pics of my new watercooling setup, which consists of:
EpoX 8K3A+, 768MB TwinMos PC2700 RAM, unlocket XP1800+, Seagate Barracuda ATA IV 80GB, GF2 MX200, DD Maze2, Eheim 1048, 12mm vinyl tubing (gonna replace that with silicone tubing), Blackice Rad, resevoir from a model airplane and Chieftech big tower:
The Front:
Front Open: Fanbus and drives:
The Goodies Inside ;-)
The Radiator 'fanduct' made by me ;-). It's completely seperated from other heatsources, keeping the water and the inside cool:
Pump and the suspension making it totally quiet, drives and MB:
Rear of the rad and exhaust fans (today i've siliconed the rad to the duct, so that all airflow goes through the rad - don't know if it has improved anything, but it can't hurt
And finally the exhaustfans from inside (they are running, so my Mavica digi-cam must have pretty good close-time ;-)
Comments/suggestions are welcome, if you want specific pictures of anything, or explanations, please
write me or here in the forums:
It's running pretty smooth at 1838MHz (10,5*175 and 2,00V) temps are:
idle: 41C and load 46C - using the XP diode (i think, no one seems to know where to find a program, that can tell me whether it uses the diode or the in-socket thermister (spelled right?
).
Any ideas how to get i higher? and do you think it's safe to up the volt's to 2.2?
BTW: the temp. on the front is the waterblock temp, measured on top of the block