Pro/Forums - View Single Post

ColdFlare · 09-14-2002, 11:43 AM

Yea I finally hooked up the maze3 to my cpu and its working!.

This is my setup

Kx7333R
Maze 3
Athlon XP 1800+ @ 1800 2.14 vcore
Heatercore with 1 enermax and 1 antec fan blowing about 40 cfm.
No shroud
Eheim 1250
Tygon tubing with water wetter, I think i put to much.

My temps are almost 50c on load ambient is 26c. System temp reading is about 36c which I think is incorrect since the panels are off it should be room temp in my case.

Temperatures taken with the probe under the cpu.

Are my temps correct? Should I be getting lower?

Should i build a shroud and get a 120mm fan on it?

Are there anyway to improve my temps?

09-14-2002, 11:43 AM	#1
ColdFlare Cooling Neophyte Join Date: May 2002 Location: New York City Posts: 42	Finished my system!! Yea I finally hooked up the maze3 to my cpu and its working!. This is my setup Kx7333R Maze 3 Athlon XP 1800+ @ 1800 2.14 vcore Heatercore with 1 enermax and 1 antec fan blowing about 40 cfm. No shroud Eheim 1250 Tygon tubing with water wetter, I think i put to much. My temps are almost 50c on load ambient is 26c. System temp reading is about 36c which I think is incorrect since the panels are off it should be room temp in my case. Temperatures taken with the probe under the cpu. Are my temps correct? Should I be getting lower? Should i build a shroud and get a 120mm fan on it? Are there anyway to improve my temps?