Pro/Forums - View Single Post - Trouble getting a maze1c to fit on my GF3 Ti200

redleader · 09-15-2002, 03:56 PM

What I did to fit my DD block on GeForce cards was to get a piece of steal (I just cut a 3*3 square from an old AT case) then drill holes in it to line up with the holes on the card. Add screws, nuts and washers and you're done.

09-15-2002, 03:56 PM	#5
redleader Thermophile Join Date: Jun 2001 Location: The deserts of Tucson, Az Posts: 1,264	What I did to fit my DD block on GeForce cards was to get a piece of steal (I just cut a 3*3 square from an old AT case) then drill holes in it to line up with the holes on the card. Add screws, nuts and washers and you're done.