Pro/Forums - View Single Post

jaydee · 09-16-2002, 09:16 PM

Well here it is. When the top is made it will have a 1/2"ID middle inlet and 2 1/4"ID or 3/16"ID outlets on the ends of the outer channel.

Probably will not have time to finish it for a while. I had a few hours to do what I done already. So here it is:

[edit]New pics comming soon. Had to switch webservers and urls.[/edit]
Outer channels is 1/4" wide .3125" deep. Inner channels are .125" wide and .25" deep. Pins are .25" squared. The block material is .5" thick, 2" wide, 3" long. That leaves .1875" of base for the outer channel and .25" base on the inner part.

09-16-2002, 09:16 PM	#1
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	My latest creation: "The Lemon Block" Well here it is. When the top is made it will have a 1/2"ID middle inlet and 2 1/4"ID or 3/16"ID outlets on the ends of the outer channel. Probably will not have time to finish it for a while. I had a few hours to do what I done already. So here it is: [edit]New pics comming soon. Had to switch webservers and urls.[/edit] Outer channels is 1/4" wide .3125" deep. Inner channels are .125" wide and .25" deep. Pins are .25" squared. The block material is .5" thick, 2" wide, 3" long. That leaves .1875" of base for the outer channel and .25" base on the inner part. Last edited by jaydee116; 10-19-2002 at 09:06 PM.