Pro/Forums - View Single Post - TECs and fault-tolerant design.

Can O' Beans · 09-22-2002, 12:03 AM

I can't remember where(here?), but I've seen someone use a "Thermal switch" hooked up to the Green ( i think) wire of the power supply.

You could put the switch on the cold plate so if the temp of the CPU/coldplate got too hot, the switch would imediately shut the whole system down.

09-22-2002, 12:03 AM	#4
Can O' Beans Cooling Savant Join Date: Aug 2002 Location: Pa - USA Posts: 264	I can't remember where(here?), but I've seen someone use a "Thermal switch" hooked up to the Green ( i think) wire of the power supply. You could put the switch on the cold plate so if the temp of the CPU/coldplate got too hot, the switch would imediately shut the whole system down.