Pro/Forums - View Single Post

jaydee · 09-23-2002, 11:21 PM

Unfortunatly I could not get a hold of any 1/2" barbs today. So for now I am just going to use 1/4"ID 3/8"OD barbs I usually use. And being that is what my system is setup for i will give it a shot. Then will change over to all 1/2"ID in and out barbs when I can get some.... I have to setup a new test bed sytem as I build a comp for my daughter out of the old one. Will try to get it setup by the weekend as I will be gone this weekend.... Hopefully have some rough results late this week or early next week. NOTE: This block IS sealed!!! clear silicone rulz!

09-23-2002, 11:21 PM	#23
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Unfortunatly I could not get a hold of any 1/2" barbs today. So for now I am just going to use 1/4"ID 3/8"OD barbs I usually use. And being that is what my system is setup for i will give it a shot. Then will change over to all 1/2"ID in and out barbs when I can get some.... I have to setup a new test bed sytem as I build a comp for my daughter out of the old one. Will try to get it setup by the weekend as I will be gone this weekend.... Hopefully have some rough results late this week or early next week. NOTE: This block IS sealed!!! clear silicone rulz!