Pro/Forums - View Single Post - My micro-channel concept block

bigben2k · 09-26-2002, 04:30 PM

I was just thinking (uh oh!)...

If someone here wants to try to reproduce this kind of cooling, one could take a copper HSF, and add barbs and a lid.

From this list , I found the following were of a copper finned design:
(of course the fin spacing is WAY off, but it's not too bad)

Thermalright SK7

Vantec 1U

Global Win CAK II 38 and CAK II 16

Evercool CUD-725

Dynatron DY1206BH-638

Cho-Liang CB0315U-17

CoolerMaster HSC-V62

Dynatron DC1206BM-R

Now, never mind how they perform as air coolers! BTW, some of these have soldered fins, some have skived fins (fins are shaved off of the copper base). The skived models would probably offer better heat transfer from the baseplate.

(I avoided listing those HSF where the middle fins were removed for the mounting bracket).

09-26-2002, 04:30 PM	#33
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	I was just thinking (uh oh!)... If someone here wants to try to reproduce this kind of cooling, one could take a copper HSF, and add barbs and a lid. From this list , I found the following were of a copper finned design: (of course the fin spacing is WAY off, but it's not too bad) Thermalright SK7 Vantec 1U Global Win CAK II 38 and CAK II 16 Evercool CUD-725 Dynatron DY1206BH-638 Cho-Liang CB0315U-17 CoolerMaster HSC-V62 Dynatron DC1206BM-R Now, never mind how they perform as air coolers! BTW, some of these have soldered fins, some have skived fins (fins are shaved off of the copper base). The skived models would probably offer better heat transfer from the baseplate. (I avoided listing those HSF where the middle fins were removed for the mounting bracket). __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101