Quote:
If you think the 1250 is scary, take a look at a 1048 some timeThe shape is kinda like a radiation hazard symbol is how I would describe it.
I've often pondered just the same thing, about widening the holes.
.
|
It does seem to be the biggest stumbling point/restriction on the pump doesn't it?. perhaps someone'll start making an anodized ALu aftermarket tuned jobbie?
...
Quote:
|
So basically the inlet holes are less restrictive to the pump than the outlet 1/2" barb.
|
*Edit!!* Are you sure?, it looks to be so tiny when you look at the area of the
three(did I say 4 earlier?) slots. the standard outlet is 3/8's is'nt it?...
I read somewhere that there's a 'ratio' for inlet~outlet, and the inlet is supposed to be X amount larger than the outlet. do you think it's tuned?, or just (good old manufacturers~) 'near enough'?...:shrug: