View Single Post
Unread 10-03-2002, 08:22 AM   #29
bigben2k
Responsible for 2%
of all the posts here.
 
bigben2k's Avatar
 
Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302
Default

Quote:
Originally posted by Volenti
I "port" all the pumps I buy ,paying special attention to the suction side, some were pretty good already and didn't show much improvement, others gained up to 25% extra head (though that was an extreme case)
I might ask you for some tips on that...

M2-MDQ-SC has a similar inlet, with 3 ports. I don't think much could be done to it, as it holds the ceramic shaft, but I guess I could hack around it, a little bit.

I'll take a pic and get back to you.
bigben2k is offline   Reply With Quote