3/8" NPT isnt smaller inner diameter than 1/2" BARBS. Just take ur pump to the hardware store.
U need a couple pieces to make it an elbow without cutting flow too much.
First piece is a 3/8" X However long u want it NIPPLE It is basically a small piece of pipe with 2 male 3/8" npt threads. YTou screw that into the outlet of pump.
This is the part that u need: male pipe to female threads. 1/2 male 3/8 female. Connect that to nipple. on th e3/8 side.
Then you need to go up to 1/2" npt cause the 3/8 elbows restrict a bit too much. You need a female female 1/2" elbow. Connect that to the reducer u just installed.
Now all you need is a 1/2 npt 1/2 barb for the 1/2 in hose.
Hope it helps
__________________
Water Cooled Inwin Q500 (Dual Rads: Rad1 = DTEK Pro Core | Rad2 = Blick Ice Estreme, Hydor L30, Dangerden Maze2, Bay Res Typhoon Reservoir, 1/2 " DD Tygon Thick Wall Hose).
Flow: Res, Pump, CPU watervlock, Y into both rads, both rads into res independently.
Athlon XP 1800+ (@ 1731 - 150mhz fsb.), on a Asus A7N266-c, and a Radeon 9000 *waiting for RMA'd Saphire 9800 ultra from Newegg)
|