Pro/Forums - View Single Post

zCereal · 10-03-2002, 03:31 PM

i am from hard ocp and i liked the review

it did what it was meant to do

show you how much you can expect a certain waterblock to cool your processor in a controlled as possible system

does the temp of the water going in and out of my waterblock matter if the temps in hte processor are lower? not even a little bit

the thin about the on die probe
yes they are inaccurate
but the inaccuracy is the same across the board

so it;s 10 degress off at low temps it's gunna be ten degree's off at higher temps

thereby giving you a good idea as to how much one black is better than another

everything else was the same so the waterblock was the only variable

do flowrates matter if the temp is lower? absolutely not as long as the temps are lower

you guys seem to want kyle to find the very best optimization for each set-up and comapre them

which would take months upon months of work for 19 blocks and is infeasible

he did the best he could by limiting all the factors down to just the waterblock

the ambient temps were the same
the rad was the same
same pump
same tubing system

the only variable is the humidity and the waterblock in use

10-03-2002, 03:31 PM	#46
zCereal Cooling Neophyte Join Date: Oct 2002 Location: Canada Posts: 12	i am from hard ocp and i liked the review it did what it was meant to do show you how much you can expect a certain waterblock to cool your processor in a controlled as possible system does the temp of the water going in and out of my waterblock matter if the temps in hte processor are lower? not even a little bit the thin about the on die probe yes they are inaccurate but the inaccuracy is the same across the board so it;s 10 degress off at low temps it's gunna be ten degree's off at higher temps thereby giving you a good idea as to how much one black is better than another everything else was the same so the waterblock was the only variable do flowrates matter if the temp is lower? absolutely not as long as the temps are lower you guys seem to want kyle to find the very best optimization for each set-up and comapre them which would take months upon months of work for 19 blocks and is infeasible he did the best he could by limiting all the factors down to just the waterblock the ambient temps were the same the rad was the same same pump same tubing system the only variable is the humidity and the waterblock in use __________________ just visiting for a bit Last edited by zCereal; 10-03-2002 at 03:37 PM.