I really like the swiftech 226w pelt setup for P4. I have a few Q's about it and pelts. (1/2 in. barbs)
...first comments from owners of this model
...how low can i reach at idle with rig below and adequate power of course
...can i run it in line with the block on ati
The last is my most important concern. i don't want a seperate setup for my vid card. Will the heat of the water be too much and overheat my vid card?
Thanks this is my first post at this forum
EDIT: The Swiftech is up and running with a monsterous lytron Cu rad and 2 10in fans. my temps at 185fsb@1.75v are as follows:
IT-&temp:
load:26c
idle:2c
Probe on the socket:
load:14.3c
idle:-11c
keep in mind i'm cooling r9700 with the same water and running Via Aqua1300 through a 20in x 11in rad!!! there is almost no flow.